线束在压接一般端子的时候，我们缘套管处不装套管该注意以下几点：
We should pay attention to the following points when the wiring harness is crimping the general terminals.
1、在工装人员调试完模具前，切不可随意操作；
1. Before tooling personnel finish debugging, do not operate at will.
2、压接时，切忌交头接耳，要集中思想，认真作业；
2, press the connection, avoid to whisper to each other, concentrate on thinking and work hard.
3、压接时我们一定要先测试拉力和端子的高度。这样我们可以根据测出的实际拉力值和高度值来作为产品是否达到要求的一个标准；
3, we must test the tension and the height of the terminals before crimping. In this way, we can according to the actual pulling force and height value as a criterion for whether the product meets the requirements.
4、压接过程中如果出现端子卡住钳口其他不正常因素时，缘套管处不装套管立即切断电动机电源，然后及时告知有关负责人；
4. If there are other abnormal factors in the crimping process when the terminal is jammed, the power supply of the motor should be cut off immediately, and the relevant person in charge should be informed in time.
5、在压接完成后一定要切断电源，以免造成不必要的工伤事故；
5, after the crimping is completed, we must cut off the power supply, so as to avoid unnecessary accidents.
6、 设备工程师在换取模具的过程中缘套管处不装套管检查是否有损伤的情况，如果出现压接钳口损伤，缘套管处不装套管及时更换。
6, the equipment engineer should check whether there is any damage in the process of changing the mould. If there is damage to the crimping clamp, it should be replaced in time.
平时一定要保护好模具，及时清理积屑，定期上油和检查调试，如果出现一个模具有问题，缘套管处不装套管做全面的检查。
Usually must protect the mold, clean up chips in time, regular oil and check and debug, if there is a mold problem, should do a comprehensive inspection.